NETGEAR WNA1000M User Manual

10 | Chapter 1: Getting Started
N150 Wireless Micro USB Adapter WNA1000M
2. Click Next. The Smart Wizard software detects the adapter.
3. Follow the onscreen prompts to install the driver and complete the installation.
How you connect to a network depends on what you selected during custom installation.
• If you installed the Smart Wizard with automatic configuration, see the following
section, Using the Smart Wizard to Connect to a Wireless Network.”
• If you installed the Smart Wizard with manual configuration, the Settings tab displays.
See Viewing Wireless Networks in Your Area on page 17.
• To use a Windows utility, see your Windows documentation or the NETGEAR
application note at
http://documentation.netgear.com/reference/enu/winzerocfg/index.htm.
Using the Smart Wizard to Connect to a Wireless Network
After the software is installed, you are prompted to connect to a wireless network.
1. One of the following screens displays:
WPS network
No WPS networks
• WPS network: A network in your area supports Push 'N' Connect (also called WPS).
Click Next, and follow the prompts to push the WPS button on your adapter and
connect without entering a password.
• No WPS networks: Select a wireless network from the list and click Next. To connect
to a secure network, you must enter its passphrase or network key.

NETGEAR WNA1000M Specifications

General

Interface	WLAN
Connectivity technology	Wireless
Chipset	-
Internal	No
Component for	PC/Laptop
Product color	Black
Wi-Fi band	Single-band (2.4 GHz)
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Maximum data transfer rate	150 Mbit/s
Minimum processor	Intel® Pentium®
Optical drive required	Yes
Compatible operating systems	Windows 7/XP/Vista (32/64-bit)
Compliance industry standards	IEEE 802.11 b/g/n
Dimensions (W x D x H) (imperial)	0.79 x 0.28 x 0.59 \

Weight and Dimensions

Depth	8 mm
Width	34 mm
Height	17 mm
Weight	4 g