Netis WF-2402 - Page 43

150Mbps Wireless-N Broadband Router User Manual
42
Figure 4-31
 WDS Name: Give a description of your wireless bridge to tell apart.
 WDS MAC Address: If the current working mode is “WDS” or “AP+WDS”, then you
need to configure wireless bridge configuration. Enter MAC address of remote access
point, at the same time the remote access point also need to configure to “WDS”
or ”AP+WDS” mode.
 Current WDS Information: It illustrates basic information of all wireless bridge that in
connection status, you may delete unnecessary bridge.
Figure 4-32
AP1:
 Select radio mode is WDS or AP+WDS in wireless management-basic of AP1.
 Click on ‘Wireless Management’- ‘AP Setup’- ‘Security’ and select and save None as
authentication type.
 Click on ‘Wireless Management’- ‘AP Setup’- ‘Security’ and select and save None as
WDS authentication type or select a WDS security type, enter key and save.