WF-2406 User Manual
4.5.2.5. WPA/WPA2-PSK
This item mixed WPA-PSK and WPA2-PSK mode, which provides higher security level; you
can configure it according with WPA-PSK or WPA2-PSK.
Figure 4-36
4.5.3. Host Filter
Figure 4-37
Wireless Access Control Status: the default is disable. You can filter wireless users by
enabling this function; thus unauthorized users can not access the network.
Rule: you can select permit or deny. The default is permit.
MAC address: input the MAC address that you want to control. The default format is
**-**-**-**-**-**（e.g.: 00-22-33-da-cc-bb）.
Follow the following steps to set Wireless Access Control:
1. Enable Wireless Access Control, then select save.
To Next Page
Loading...
