Netis WF-2406 - Factory Default Reset; Hardware Installation Procedures

WF-2406 User Manual
8
Off
LAN Connection abnormal
Rear panel
Figure 2-2
Description
Function
PWR
Connect to Power adapter, please don‟t use the unknown
power adapter, otherwise your device may be damaged.
LAN
Connect with computer NIC or Ethernet device
WAN
Internet access
Reset
Restore settings
WPS
WPS settings
2.3. Restore to factory configuration
If the router ever freezes in a setting change process or if you can‟t access it because you can‟t
remember the IP you have given it or other problem, you may have to utilize the reset button on
the back of the router to put it back to factory settings. You have to press and hole this button
for a few seconds (2-6s) with a pencil when it is working, then release and it will restore
settings to the factory configuration.
The other way to restore factory settings is through the same user interface used in setup.
Click on „System management‟- „Restore‟, and click on the „Restore‟ button.
2.4. Hardware Installation Procedures
The procedures to install the 300Mbps Wireless-N Gigabit Router please refers to the following
picture