Netis WF-2406 - Wireless Advanced

WF-2406 User Manual
52
AP2:
 Select radio mode is „REPEATER‟ in wireless management-basic of AP2.
 Click „AP Scan‟ in wireless management-basic of AP2 ,and select „Netis1‟ and Connect ,
then the „Repeater SSID‟ and „Channel‟ become same as AP1.
 The IP address of AP2 should be 192.168.1.x (1<x<255,e.g.: x=8).
 Select „LAN setup‟-„DHCP server‟ ,select disable DHCP server.
Figure 4-42
AP3:
 Select radio mode is „REPEATER‟in wireless management-basic of AP3.
 Click „AP Scan‟ in wireless management-basic of AP3 ,and select „Netis1‟ and Connect ,
then the „Repeater SSID‟ and „Channel‟ become same as AP2.
 The IP address of AP3 should be 192.168.1.x (1<x<255),but different from AP2.
 Select „LAN setup‟-„DHCP server‟ ,select disable DHCP server.
4.5.6. Wireless Advanced
These settings are only for more technically advanced users who have a sufficient knowledge
about wireless LAN. These settings should not be changed unless you know what effect the
change will have on your AP.