Email logic menu
The Email logic menu shows a screen like the one below.
/------------------------/
/ Email logic /
/------------------------/
Email 1 Email 2 Email 3 Logic:
Wait...........: X<-- 0 0 And
Fault..........: X 0 0 And
Permanent Fault: X 0 0 And
N/A............: 0 0 0 And
N/A............: 0 0 0 And
N/A............: 0 0 0 And
N/A............: 0 0 0 And
With this menu it can be established to which addresses the e-mails will be sent when certain
events occurs. One or more addresses can be associated with each event and in the latter case,
when the event occurs, notification e-mails will be sent to all the addresses associated with it.
NOTE: use the ENTER key to change the selected configuration (“X” or “0”).
X: when the event occurs, NetMan plus sends a notification e-mail to the corresponding
addresses (see “Email logic menu” to set the addresses);
0: when the event occurs, NetMan plus does not send a notification e-mail to the
corresponding addresses;
The following table describes the meaning of the events. These can vary depending on the inverter
connected.
The inverter is waiting the connection to the grid
The inverter is not connected to the grid
To Next Page
Loading...
