NetMan 102 plus - Backup Battery

- ENGLISH -
- 80 -
Activation menu
The Activation menu shows a screen like the one below.
/------------------------/
/ Activation /
/------------------------/
Enable telnet..:[ON/off]<-- Enable FTP.....:[ON/off]
Enable HTTP....:[ON/off] Enable DataLog.:[ON/off]
Enable Modem Tx:[on/OFF] Enable Modem Rx:[on/OFF]
Enable SNMP....:[on/OFF] Enable Email...:[ON/off]
Enable UDP.....:[ON/off] Enable Report..:[ON/off]
With this menu the services implemented in NetMan plus can be activated or deactivated:
NOTE: use the ENTER key to change the selected configuration (“ON” or “OFF”).
ON (green characters): service active
OFF (red characters): service not active
It is recommended to activate only the services used. The SNMP and Modem services are not
supported.
Services 2 menu
/------------------------/
/ Services 2 /
/------------------------/
WakeOnLan addr.:<--
WakeOnLan delay:
Activation.2...:
Sensors config :
I/O Sensors....:
Threshold sens.:
With this menu the configuration screens of the various services can be accessed as described in
the following table.
Menù
Funzione
WakeOnLan addr.
To configure the Wake-on-LAN service
WakeOnLan delay
Activation 2
To configure the services to be activated
Sensors. config
To configure the environmental sensors
I/O Sensors
Threshold sens