NetModule NB3700 - Page 192

NB3700 User Manual 3.8
A.5. SDK Examples
Event Description
best-operator.are This script will scan for operators on startup and choose the
one with the best signal
candump.are This script can be used to receive CAN messages
config-summary.are This script shows a summary of the currently running con-
figuration.
dio-monitor.are This script monitors the DIO ports and sends a SMS to the
specified phone number.
dio-server.are This script implements a TCP server which can be used to
control the DIO ports.
dio.are This script can be used to set a digital output port.
dynamic-operator.are This script will scan Mobile2 and dial the appropriate SIM
on Mobile1
email-to-sms.are This script implements a lightweight SMTP server which is
able to receive mail and forward them as SMS to a phone
number.
etherwake.are This script can be used to wake up a sleeping host (WakeOn-
Lan)
gps-broadcast.are This script sends the local GPS NMEA stream to a remote
UDP server (incl. device identity).
gps-monitor.are A script for activating WLAN as soon as GPS position
(lat,lon) is within a specified range.
gps-udp-client-
compat.are
This script sends the local GPS NMEA stream (incl. seri-
al/checksum) to a remote UDP server.
gps-udp-client.are This script sends the local GPS NMEA stream to a remote
UDP server.
led.are This script can be used to set a LED
modbus-rtu-master.are This script can be used to read messages from the serial
port.
modbus-rtu-slave.are This script implements a modbus slave server
192