Netum NT-9600 User Manual

8
Enable scanner ID report
Display scanner ID at the
receiving end.
Disable scanner ID
report
Do not display scanner ID at
the receiving end.
Set Tab between ID and
barcode
Set the delimiter between ID
and barcode a Tab when ID
report is enabled. (Default
setting)
e.g.: scanner
ID=10, barcode=
12345; display: 10
12345
Set White Space between
ID and barcode
Set the delimiter between ID
and barcode white space when
ID report is enabled.
e.g.: scanner
ID=10, barcode=
12345; display: 10
12345
Set “-” between ID and
barcode
Set the delimiter between ID
and barcode a “-” when ID
report is enabled.
e.g.: scanner
ID=10, barcode=
12345; display:
10- 12345
Restore all original
receiver settings
Restore this module to original
settings.
Save & Exit
Note: After a programming operation, the reader will emit beeps and the light
will flash to indicate association to the base. Put the reader close to the base.
Unplug the base for a few seconds then plug it back. The light and the beeper
will stop on a successful setting. Then the reader will perform on the new setting.
Repeated code detection setting
Setting code
Function
Description
Enable repeated code
detection
Enable repeated
code detection.
Note: this setting
will be
automatically saved
and remain
effective after
power failure.
When this function
is activated, the
scanner will give an
error alarm with 5
beeps and
automatically
cancel the last
repeated code if a
repeated code is

Netum NT-9600 Specifications

General

Brand	Netum
Model	NT-9600
Category	Barcode Reader
Language	English