2
About The Meter
METER BUTTONS
SETPTS Button
This button functions only in the run mode. When the meter is in the run mode, press this button
to sequentially recall the previous setpoint settings. After using the
¶
/MAX and
©
/DEV buttons
to alter these settings as desired, press the SETPTS button to store these new values.
Unless you press the SETPTS button within 20 seconds to store your input, the meter will scroll
to setpoint 2 and retain the last value stored.
If the dual relay option is not installed, pressing the SETPTS button will display "V.-03"
which is the meter's software version.
¶
/MAX Button
During the run mode, press the
¶
/MAX button to recall the PEAK reading since the last press of
the RESET button. To return to the current readings without resetting the PEAK reading, press
the
¶
/MAX button. To reset the PEAK reading, press the RESET button.
During the configuration mode, use the
¶
/MAX button to change the values of the flashing digit
shown on the display and/or toggle between menu choices, such as "R.1=F" or "R.1=C". When
configuring your setpoint values, press the
¶
/MAX button to increment the flashing digit from
0 to 9 by 1's.
©
/DEV Button
During the run mode press the
©
/DEV button to display the deviation from setpoint 1.
When configuring your setpoint values, press the
©
/DEV button to scroll to the next digit.
6
To Next Page
Loading...
