Newport INFINITY INFCR - 4.12 Lock Out Configuration (LK.CF)

4
Configuring The Meter
4.12 LOCK OUT CONFIGURATION (LK.CF)
Use Lock Out Configuration (LK.CF) for the following:
* To enable or disable setpoint changes
* To enable or disable the RESET button in the run mode.
4.12.1 To Enable or Disable Setpoint Changes
1. Press the MENU button until the meter shows "LK.CF" (after "O.T.S.O" ).
2. Press the
©
/DEV button. The meter shows "SP.=E".
3. Press the
¶
/MAX button to toggle between:
"SP.=E" To enable setpoint changes
"SP.=D" To disable setpoint changes
4. Once desired mode shows, press the MENU button to store the change.
4.12.2 To Enable or Disable the RESET button in the Run Mode
1. If accessing this function from the main menu, press the MENU button until the meter
shows "LK.CF". Otherwise, proceed to step 2.
2. Press the
©
/DEV button until the meter shows "SP.=E" .
3. Press the
©
/DEV button again. The meter shows "RS.=E" .
4. Press the
¶
/MAX button to toggle between:
"RS.=E" To enable the RESET button in the run mode
"RS.=D" To disable the RESET button in the run mode
5. Once desired mode shows, press the MENU button to store the change. The meter
returns to the run mode.
4.12.3 To Enable DisplayÕs Program Version
1. Press the
©
/DEV button. The meter shows one of the following:
* "L.3=0" "SETPTSÓ button will display setpoint values.
* "L.3=1" "SETPTS" button will display "v.-03" which is the meter's current software
version.
2. Press the
¶
/MAX button to toggle between the choices above.
3. Press the MENU button to store the changes.
If your meter does not have the relay option, setpoint menu items above will not be
available and SETPTS button will always display the meter's software version. These
units will have +OL (overload) or +OPEN memory indicated by Alarm 1 & 2 LED
displays. LEDs can be reset by pressing MENU then RESET button or by power
OFF then ON. These units can not use analog output proportional to error from
setpoint 1, under menu OT.CF, 0.3=P.
28
Note
☞