M94011A
Oriel
®
LCS-100
TM
Small Area Sol1A
- 12 -
3 UNPACKING AND ASSEMBLING THE SYSTEM
The optics beam turner output port was covered for its protection during transportation. Before operating,
the plastic protector must be removed. Save the plastic protector in case you need to store or transport
the unit in the future.
The preferred mounting configuration for the illuminator is mounted to an optical table or breadboard type of
mount plate using the Newport Model 75 Mounting Rod. This rod has 4 mount holes that are spaced to be
compatible with inch and metric (25mm) holes. This rod provides the quickest approach to fine-tune the height
while maintaining rotational and planar alignment with the work plane. For additional mounting configurations,
see Section 6.3.
3.1 MODEL 75 HEAVY DUTY MOUNTING ROD
Remove the Newport Model 75 Mounting Rod from its packaging. Use the (4) supplied 1/4 - 20 x 5/8”
or (4) M6 x 16 screws to mount the Rod to a suitable location on an optical table or optional
baseplate. Make sure the nylon rack is facing the operator position.
Figure 3: Model 75 Rod Mounting
To Next Page
Loading...