Newport Oriel LCS-100 - Figure 8: Filter Assembly Insertion and Removal; Figure 9: Filter Assembly Engagement

To Next Page

To Previous Page

M94011A

Oriel

LCS-100

Small Area Sol1A

- 16 -

Figure 8: Filter assembly insertion and removal

7. If a filter assembly is to be installed, remove it from its packaging and orient it so that it is angled

away from the lamp toward its bottom as shown in Figure 8.

8. Lower it slowly into place with a slight tilt to engage one of the holes with its corresponding

retaining stud. Pivot the filter assembly to engage the other retaining stud as shown in Figure 9.

Figure 9: Filter assembly engagement

9. Replace the two thumbscrews, as shown in Figure 7.

10. If you want to install a lamp, proceed to Section 5 for instructions.

11. Install the LCS-100

top cover with the grooved edge engaging the front panel, sliding it straight

down. Replace the top 4 Phillips head screws, tightening securely.