Newport Oriel LCS-100 - Figure 13: Lamp Seating; Figure 14: Lamp Held While Retaining Clip Engaged

M94011A
Oriel
®
LCS-100
TM
Small Area Sol1A
- 19 -
Figure 13: Lamp seating
9. Engage the lamp retaining clip over the back side of the reflector rim on either side, then within
the grooved retaining post above it. Engage the other side similarly, so that the clip sits within the
groove of the retaining post above it, as shown in Figure 14.
Figure 14: Lamp held while retaining clip engaged
10. While sliding the power supply connector into the cutout in the rear of the lamp cage, connect it to
the lamp connector, being careful not to stress or excessively pull on the wires at the lamp ends,
as shown in Figure 15. Note that the connector is keyed so that it may only engage with the
proper polarity.