M94011A
Oriel
®
LCS-100
TM
Small Area Sol1A
- 13 -
3.2 POST CLAMP AND ANGLE BRACKET
Remove the Newport Model 370-RC Post Clamp and 360-90 90 Degree Angle Bracket from their
packaging. Use the (4) supplied 1/4 - 20 x 5/8” screws, (4) split lock washers, and (4) flat washers to
attach them as shown. The knob with the model number on it will be used to loosen the clamp. This
works better for a right-handed person when it is on the right side, assembled as shown.
Figure 4: 90 Degree angle bracket to Post Clamp assembly
3.3 ANGLE BRACKET MOUNTING TO BOTTOM OF LCS-100
TM
Turn the LCS-100
TM
unit upside down on a clean non-marring surface. Use the supplied 1/4 - 20 x
7/8” screws, 1 split lock washer, and 1 flat washer to attach them as shown. Note that if the user
prefers, it can be mounted on the opposite side from that which is shown, if the nickel plated flat head
screw is replaced by one of the 1/4 - 20 x 7/8” screws.
Figure 5: 90 Degree angle bracket assembly to bottom of unit
To Next Page
Loading...