USB-Link™ 3 Installation and Setup Manual
Chapter 3: Installing the Drivers and Setting Up the Device 34
The Network Selection screen is displayed.
6 Click Connect.
The device is now connected and ready to use.
7 Proceed to Step 3: Test the Connection (pg. 36)
5 Select USBL3_xxxxxx from the list (xxxxxx represents the serial number of the USB-Link™ 3).
NOTE: If USBL3_xxxxxx is not displayed, make sure you are connected to the vehicle and are within
range (i.e., within 50 ft.). You may need to move your PC closer to the vehicle.
Figure 3.13 Network Selection Screen
To Next Page
Loading...
