USB-Link™ 3 Installation and Setup Manual
Chapter 3: Installing the Drivers and Setting Up the Device 38
If the Connection Indicator button is red (i.e., Not Connected), do one of the following:
For a wireless connection:
• In the Device list, make sure that the appropriate device is selected, for example:
- USB-Link3, Bluetooth or
- USB-Link3, WiFi
• In the Protocol list, make sure that the appropriate protocol is selected, for example SAE
J1939 Protocol.
• Check to ensure that the connections between the USB-Link™ 3 and the vehicle are secure
(i.e., the Diagnostic Connector).
• Check to make certain that the Power LED on the USB-Link™ 3 is illuminated.
For a wired connection using a USB cable:
• In the Device list, make sure that the appropriate device is selected, for example USB-Link3, USB.
• In the Protocol list, make sure the appropriate protocol is selected, for example SAE J1939 Protocol.
• Check to ensure that the connections between the USB-Link™ 3 and the PC are secure
(i.e., the USB cable).
• Check the connections between the USB-Link™ 3 and the vehicle (i.e., the Diagnostic Connector).
• Check to make certain that the Power LED on the USB-Link™ 3 is illuminated.
6 Click on the Component Info button.
NOTE: For additional information, refer to Step 2: Connect the USB-Link™ 3 to a Vehicle (pg. 27)
To Next Page
Loading...
