© National Instruments | A-1
A
Where to Go from Here
This section lists where you can find example programs for the cDAQ chassis and C Series
modules and relevant documentation.
Example Programs
NI-DAQmx software includes example programs to help you get started programming with the
cDAQ chassis and C Series modules. Modify example code and save it in an application, or use
examples to develop a new application, or add example code to an existing application.
To locate NI software examples, go to
ni.com/info and enter the Info Code daqmxexp. For
additional examples, refer to
zone.ni.com.
To run examples without the device installed, use an NI-DAQmx simulated device. For more
information, in Measurement & Automation Explorer (MAX), select Help»Help
Topics»NI-DAQmx»MAX Help for NI-DAQmx and search for simulated devices.
Related Documentation
Each application software package and driver includes information about writing applications
for taking measurements and controlling measurement devices. The following references to
documents assume you have NI-DAQmx 9.7 or later.
NI cDAQ Chassis Documentation
The NI cDAQ-91xx Quick Start packaged with your cDAQ chassis, describes how to install your
NI-DAQmx for Windows software, how to install the cDAQ chassis and C Series I/O module,
and how to confirm that your device is operating properly.
The NI cDAQ-91xx Specifications lists all specifications for your cDAQ chassis. Go to
ni.com/manuals and search for your cDAQ chassis.
The NI cDAQ Chassis Calibration Procedure contains information for calibrating all National
Instruments CompactDAQ chassis. Go to
ni.com/manuals and search for your cDAQ
chassis.
C Series I/O Module Documentation and Specifications
For module specifications, refer to the documentation included with your C Series I/O module
or go to ni.com/manuals.
To Next Page
Loading...
Need help?
General
