Menu system
When the door to the heat pump is opened, the menu
system’s four main menus are shown in the display as
well as certain basic information.
INDOOR CLIMATE
HEAT PUMP INFO
HOT WATER
SERVICE
Indoor temperature - (if room sensors are installed)
Hot water temp.
Temporary lux (if activated)
Outdoor
temperature
Estimated amount of hot water
Information about
operation
Menu 1 - INDOOR CLIMATE
Setting and scheduling the indoor climate. See informa-
tion in the help menu or user manual.
Menu 2 - HOT WATER
Setting and scheduling hot water production. See inform-
ation in the help menu or user manual.
This menu only appears if a water heater is docked to
the heat pump.
Menu 3 - INFO
Display of temperature and other operating information
and access to the alarm log. See information in the help
menu or user manual.
Menu 4 - HEAT PUMP
Setting time, date, language, display, operating mode
etc. See information in the help menu or user manual.
Menu 5 - SERVICE
Advanced settings. These settings are only intended for
installers or service engineers. The menu is visible when
the Back button is pressed for 7 seconds, when you are
in the start menu. See page 43.
Symbols in the display
The following symbols can appear in the display during
operation.
DescriptionSymbol
This symbol appears by the information
sign if there is information in menu 3.1 that
you should note.
These two symbols indicate whether the
compressor or addition is blocked in F1155.
These can, for example, be blocked depend-
ing on which operating mode is selected
in menu 4.2, if blocking is scheduled in
menu 4.9.5 or if an alarm has occurred that
blocks one of them.
Blocking the compressor.
Blocking additional heat.
This symbol appears if periodic increase or
lux mode for the hot water is activated.
This symbol indicates whether "holiday
setting" is active in 4.7.
This symbol indicates whether F1155 has
contact with Uplink.
This symbol indicates the actual speed of
the fan if the speed has changed from the
normal setting.
Accessory NIBE FLM is needed.
This symbol indicates whether solar heating
is active.
Accessory needed.
This symbol indicates whether pool heating
is active.
Accessory needed.
This symbol indicates whether cooling is
active.
Accessory needed.
NIBE F1155Chapter 7 | Control - Introduction38
To Next Page
Loading...
Need help?
General
