Mercury 310 Automated Gate System
Installation and Programming Manual
22
CONTENTS
CONTENTS
1: INTRODUCTION ....................................3
1.1 OVERVIEW ........................................3
1.2 CONTROL BOXES ...........................4
1.3 ACUTATORS AND ACCESSORIES 5
2: IMPORTANT SAFETY INFORMATION ..6
3: INSTALLATION SAFETY .....................14
4: TOOLS AND MATERIALS ....................14
5: ACBOX310 INSTALLATION.................16
1.1.1 Earth Ground 18
5.1 ACBOX310 POWER .......................18
5.1.1 Introduction and Warnings 8
5.1.2 Wire Run Sizing 19
5.1.3 Power Supply Wiring 19
6: SOLARBOX310 INSTALLATION .........24
6.1 SOLARBOX310 POWER ................26
6.1.1 Introduction and Warnings 26
6.1.2 Solar & Battery Requirements 26
7: LINEAR ACTUATORS ..........................30
8: PROGRAMMING AND SETUP .............34
8.1 LIMIT LEARN PROCEDURE .........35
8.2 STANDBY MODE ............................37
8.3 FUNCTION KNOB SETTINGS ......38
8.4 ACCESSORY INSTALLATION ......40
8.5 OXI RADIO PROGRAMMING ........42
8.5.1 Deleting Transmitters 43
8.6 FIRMWARE UPDATE .....................44
9: CONTROLLER OPERATION ...............45
9.1 GATE CONTROL BUTTONS .........46
9.2 POWER STATUS LEDS .................47
9.3 FAIL-SAFE & ALARM BUTTONS .48
10: INPUTS AND OUTPUTS
....................49
10.1 CONTROL INPUTS .......................51
10.1.1 Remote/Radio Input 51
10.1.2 Guard Station Input 5 2
10.1.3 Fire Input 5 3
10.1.4 Emergency Gate Access 53
10.2 SAFETY SENSOR INPUTS ...........54
10.2.1 Auto Sensor Scan 54
10.2.2 Manual Sensor Scan / Clear 54
10.2.3 Sensor Activation (10K / BlueBUS) 55
10.3 BLUEBUS INPUT ..........................56
10.3.1 BlueBUS Intallation 56
10.4 10KΩSENSORINPUTS ............58
10.4.1 10K Ω Sensor Installation 58
EMX IRB-MON (Photo Eye) Wiring 58
EMX IRB-RET (Photo Eye) Wiring 59
EMX NIR-50-325 (Photo Eye) Wiring 59
Seco-Larm Enforcer Retro-Reective (Photo Eye) 59
Seco-Larm Enforcer Thru-Beam (E-960-D90GQ) 60
Transmitter Solutions iGaze RE Kit (Photo Eye) 60
EMX WEL200 (Edge Sensor) Wiring 60
Generic 2-Wire Edge Sensor Wiring 61
10.5 LOOP INPUTS ................................61
10.5.1 Obstruction Loop Input 62
10.5.2 Shadow Loop Input 62
10.5.3 Exit Loop Input 62
10.6 LOOP INSTALLATION ..................63
10.6.1 Vehicle Detectors And Loops 64
10.6.2 Security Gate Application Rules 64
10.6.3 Detector Logic 65
10.6.4 Loop Diagnostics 65
10.6.5 Loop Layout (Dual Swing/TITAN) 66
10.7 LINEAR ACTUATOR INPUTS ......67
10.8 POWER INPUTS ............................68
10.9 POWER OUTPUTS ........................69
1: MANUAL RELEASE .............................70
11: ERROR, STOP, AND LED CODES
......74
12: SOLAR REQUIREMENTS
..................76
13: MAINTENANCE
.................................77
14: TROUBLESHOOTING
........................78
15: INSTALLATION CHECKLIST
............79
16: WARRANTY
.....................................80
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com