Nidec Control Techniques Digitax-SF DA24A23 - Precautions for Testing; Testing Procedure


Digitax SF Instruction Manual
Operation
６
6. Operation
2. Position Control Mode
2. Position Control Mode
Precautions for Testing
Testing Procedure
Before applying power to each drive or motor, be
sure that all wiring has been performed properly.
Set the parameters correctly before testing.
Check motor motion rst with no machine connected.
For a brake-equipped motor, be sure to disengage the brake
before driving the motor.
Step Operation
Step 1

Step 2
drive
Step 3
AC Supplydrive
Step 4

Step 5

rpm


Step 6
correct direction




