Nidec Control Techniques Digitax-SF DA24A23 - Internal Position Command（Point Table; Position Control Mode


Digitax SF Instruction Manual
6. Operation
5. Position Control Mode
5. Position Control Mode
1. Internal Position Command（Point Table）

drive


Positioner Drive


Digitax SF
Digitax SF Connect
using Digitax SF Connect
1. Conguring Parameters
2. Creating Point Table and Testing
Digitax SF Connect


Digitax SF Connect
Digitax SF Connect u
3. Operation by User I/O


Precautions
1. 


Position error
Position error
2. 


