Nidec Control Techniques Digitax-SF DA24A23

To Next Page

To Previous Page



Digitax SF Instruction Manual

Operation

６

6. Operation

4. Torque Control Mode

Precautions for Testing

Testing Procedure

Before applying power to each drive or motor, be

sure that all wiring has been performed properly.

Set the parameters correctly before testing.

Check motor motion rst with no machine connected.

For a brake-equipped motor, be sure to disengage the brake

before operating the motor.

Step Operation

Step 1



Step 2

drive

Step 3

AC Supplydrive

Step 4

Set [Analog torque: Speed limit (No.152)] to a su󱐰ciently small value (around 500 [rpm]).

Step 5



Step 6



Step 7







Step 8





Nidec Control Techniques Digitax-SF DA24A23 - Page 252