11
Contents Index
Shoot View Connect The Setup Menu Technical Notes
Point-and-Shoot Photography and Movie Recording
The indicators displayed vary with camera settings and
shooting conditions. Some indicators only appear for a few
seconds after the camera is turned on or an operation is
performed; to display the indicators again, tap A.
When the shutter-release button is pressed halfway, focus
status is shown as follows:
The focus area or in-focus indicator lights green when the
camera focuses. If the camera fails to focus, the focus area or in-
focus indicator will flash red; recompose the shot and try again.
Battery level is shown as follows:
The number of exposures remaining varies with available
memory and the option selected for Image mode (A 24).
Amounts over 10,000 are shown as “9999”.
Motion detection: If the camera detects subject movement
or camera shake, it will raise ISO sensitivity for faster shutter
speeds and the shutter speed and aperture will be displayed in
green.
At the default flash mode of w Auto, the flash fires to
provide additional lighting as required. To turn the flash off,
select y Off for Flash mode (A 20).
If O flashes in the monitor during shooting, reset the clock
(A 64).
Face detected
c
No face detected
Q
Digital zoom in effect
D
Battery charged.
e
Low battery. Charge camera.
NBattery
exhausted.
Battery exhausted. Charge camera.
To Next Page
Loading...
Need help?
General
