Chapter 6 Installing the Device Driver
3 After Installation
- 29 -
6
3
After Installation
Now, install the separately sold PC application software to connect to the DS-U1. Launching this
software enables the DS-U1 to perform the following functions.
1) Display images captured by the microscope on the PC monitor
2) Confirm and change DS-U1 settings (photographing conditions, etc.)
3) Display and control the operating status of the Nikon i-series Upright Microscope (via
DS-U1)
For information on installation and operation of the application software, refer to the instruction
manual.
To Next Page
Loading...
