3
General information
Important information
Safety
Power supply
Heat pump
The heat pump must undergo suitable service inspections under applicable legislation and regulations to keep it in good condition and
in compliance with safety and environmental requirements.
Responsibility for maintenance of the heat pump rests with the owner/user.
CAUTION
Do not turn on the power supply for the unit until the domestic ho water tank and central circuit heating has been filled
with water.
CAUTION
Always disconnect the power supply to the unit if an error occurs that cannot be rectified via the control panel.
CAUTION
If an error occurs on electrically conductive parts of the unit, alway contact an authorised electrician to rectify the error.
CAUTION
Always disconnect the power to supply to the unit before opening the unit doors, for instance for installation, inspection
and cleaning.
CAUTION
Avoid direct contact with the heating system pipes in the heat pump as they can get very hot.
CAUTION
To secure the heat pump against damages, it is fitted with the following safety equipment:
• Electronic monitoring of the temperature
• 2,5 bar safety valve for central heating and buffertank
• Frost protection function that ensures that the compressor starts up at low temperatures (requires an undisrupted
power supply to the unit)
• Low and high pressure switch for compressor
To Next Page
Loading...
Need help?
General
