6
Data plate
Warnings and regulations
Inappropriate use
No duct connection
Opening the unit
Unit in standby mode
Data plate
Nilan’s data plate is located on the inside of the electrical
cabinet, which is mounted on the unit. The data plate holds the
following information:
1.
Unit type
Order no.
Serial no.
Note!
When contacting Nilan A/S with questions regarding a product, please be ready to quote the unit type, order no. and serial no.
This information will enable the service department to identify any relevant information about your unit. The service depart-
ment will then be able to provide you with information and to answer questions about the unit, its parts and the software used.
1
2
3
WARNING
The unit must not be used for extraction of shavings or in areas with a risk of explosive gases.
ATTENTION
If one or more of the spouts are not connected to a duct, a protective net with a mesh width of max 20 mm must
be fi tted on this/these.
WARNING
Do not open the service doors until the power supply has been disconnected on the safety switch and the fans
have stopped.
In accordance with EN 1886, for safety reasons you should only be able to open the service doors by means of a
tool. For this purpose, please use the supplied “key”. Alternatively, you can use a large screwdriver.
ATTENTION
When a ventilation unit is not in operation, humidity from the rooms may penetrate into the ducts and create
condensation. Condensate water may leak from the valves and cause damage to furniture and fl oors.
Condensation may also form inside the unit, which can damage its electronics and fans.
To Next Page
Loading...
Need help?
General