Nilfisk-Advance S2 L User Manual

C343
4
09/2017
S2 / S3
GB
Vacuum cleaner description
Optional kits
Please contact the manufacturer’s sales network for
information on optionals.
Instructions for installing the optionals are included in the
conversion kit.
WARNING!
Use only supplied and authorized genuine spare parts.
Accessories
Various accessories are available; refer to the manufacturer’s
accessory catalogue.
WARNING!
Use only genuine accessories supplied and
authorized by the manufacturer.
Packing and unpacking
Dispose of the packing materials in compliance with the laws
in force.
Figure 3
Model
S2 L - M - H
(40 L)
S3 L - M - H
BDC1330
(50 L)
S3 L - M - H
E-VAC2000
BDC1330
(100 L)
A (mm) 700 700 700
B (mm) 860 860 860
C (mm) 1350 1750 1750
Weight with
packing (kg)
80 86 89
Unpacking, moving, use and storage
Operate on at, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight).
Vacuum Cleaner Parts and Labels
Figure 1
1. Identication plate which includes:
Model code, Class (L - M - H), Technical Specications
(see table on page 6), Serial N°., CE Mark, Year of
manufacture, Nominal network voltage.
2. Dust container
3. Dust container release lever
4. Inlet
5. Inlet (only for Class M - H vacuum cleaners).
6. Inlet plug
7. Accessories compartment
8. Warning label for ClassL -M - H vacuum cleaners.
9. Outlet
10. Attention plate
Draws the operator’s attention to the fact that the lter
must only be shaken when the vacuum cleaner is turned
o󰀨 (see also par. “Primary lter shaker”).
11. Plug for connecting the vacuum cleaner to an electrical
socket.
Figure 2
1. Class L label
2. Class M label
3. Class H label
The class L and M labels contain pictograms with the
following meanings:
WARNING!
This vacuum cleaner contains dust
hazardous for the health.
Only authorised personnel wearing suitable
personal protective equipment should
empty and service the vacuum cleaner, including
removing the means used to vacuum the dust. Do not
use without the complete lter system in place.
The class H label contains the above text.
This vacuum cleaner creates a strong air ow which is drawn
in through the inlet (4 - Fig. 1) and blown out through the
outlet (9 - Fig. 1).
Before turning on the vacuum cleaner, t the vacuum hose
into the inlet and then t the required tool on to the end part
(refer to the manufacturer’s accessory catalogue or Service
Centre).
The diameters of the authorised hoses are given in the
technical specications table.
The vacuum cleaner is equipped with a primary lter which
enables it to be used for the majority of applications.
Besides the primary lter, which retains the most common
types of dust, the vacuum cleaner can be tted with a
secondary lter (absolute H class) with a higher ltering
capacity for ne dusts and dusts that are hazardous to health.

Nilfisk-Advance S2 L Specifications

General

Brand	Nilfisk-Advance
Model	S2 L
Category	Vacuum Cleaner
Language	English