S2 / S3
09/2017
13
C343
GB
Tightness inspection
Hoses check
Make sure the connecting hoses (Fig. 17) are in a good
condition and correctly xed.
If the hoses are damaged, broken or badly connected to the
unions, they must be replaced.
When sticky materials are treated, check for possible clogging
along the hose, in the inlet and on the bae plate inside the
ltering chamber.
Scrape inlet (2, Fig. 17) from the outside and remove the
deposited waste as indicated in gure 17.
Filtering chamber tightness check
If the gasket (1, Fig. 19) between the container (4) and the
ltering chamber (3) fails to guarantee tightness:
■ Loosen the four screws (2) that lock the ltering chamber
(3) against the vacuum cleaner structure.
■ Allow the ltering chamber (3) to lower down and tighten the
screws (2) once it has reached the tightness position.
If an optimal seal cannot be obtained and the gasket is torn or
cracked, etc. it must be replaced.
Disposing of the vacuum cleaner
Figure 19
Dispose of the vacuum cleaner in compliance with the laws in
force.
■ Proper disposal (electric and electronic waste).
(Applicable in the European Union and in countries
providing a separate collection system)
The above symbol (Fig. 19), which is present on the product
or in its documentation, indicates that the product cannot be
disposed of together with other domestic waste at the end of
its life cycle.
To prevent damage to the environment or health caused by
improper waste disposal, please separate this product from
other waste and recycle it responsibly in order to support the
sustainable reutilisation of material resources.
This product can not be disposed of together with other
commercial waste.
To Next Page
Loading...
Need help?
General
