63Service Manual – SC900 34 - Scrub System, Cylindrical
Removal and Installation
Scrub Skirt
Removing the scrub skirt (B) allows easy access to
the scrub deck components. It is held in place with 4
screws (A) on the sides, and a tab in the center.
1. Using a 3mm hex key, remove the 4 screws and
washers (A).
2. Slide the skirt toward the front to free the center
tab from the solution tank.
Scrub Brush Motor
1. Lower the scrub deck and remove the Scrub skirt as
described above.
2. Using a 3/8” socket, remove the screw (A) that secures
the belt cover (B) to the scrub deck, and remove the
cover.
3. Walk the stretch belt (D) off the pulleys.
4. Remove the three screws (C) that secure the motor to
the scrub deck.
5. Disconnect the motor connector, and remove the motor
from the scrub deck.
6. During replacement, to aid in walking the stretch belt
back on the pulleys, use a 3/8” socket extension to rotate
the pulley.
A
B
A
B
B
C
D
To Next Page
Loading...
Need help?
General
