39
7 Filter and dust bags - Silver/Sopra 160, Gold/Sopra 260,
Gold RRC/Sopra 260 RRC
7.3 Replacing the dust bag
The machine is supplied with a dust bag.
Replace the dust bag in the following way:
1. Release the two handles clamped on to the dust container.
Free them by pulling the handles outwards away from the
container.
2. Lift off the container.
3. Shake the dust from the bag fi lter. It may be advantageous
for the fi lter to be installed in the container in such a way that
dust in the fi lter can be shaken down into the dust container.
4. Lift out the bag fi lter.
5. Remove the dust bag by taking hold of the cardboard
stiffener and carefully pulling out the card and bag from
the container, Fig. 23. Fold down the perforated part of the
cardboard towards the opening of the bag in order to prevent
the bag contents to leak out.
6. Empty the container of dust.
7.1 Replacing the bag fi lter
A bag fi lter must always be installed in the dust container.
Clean the fi lter in the following way:
1. Release the two handles clamping the dust container.
Free them by pulling the handles outwards away from the
container, Fig 20.
2. Do not remove the fi lter from the container. Instead, give the
fi lter a light shaking inside the container to loosen dust from
the fi lter allowing it to fall into the container, Fig. 21.
3. Lift out the bag fi lter. If a dust bag is being used - remove the
dust bag. Then empty the container of any remaining dust in
a suitable place.
7.2 Fitting the bag fi lter
Replace the bag fi lter in the machine as follows:
1. Replace the cleaned/shaken bag fi lter in the container, Fig.
22. Make sure the fi lter support fi ts into the inner edge of the
dust container properly. Check that the fi lter is fi tted the right
way up - the cloth handle on the fi lter should be visible.
2. Then replace the dust container with the bag fi lter in the
cleaner’s vacuum unit.
3. Close the container on the vacuum unit by applying inward
pressure to the two handles to ensure the vacuum unit and
dust container are fi tted together properly.
7.4 Fitting the dust bag
Replace the dust bag as follows:
1. Fit the dust bag’s card with a hole into the bag holder, Fig.
24.
2. Replace the cleaned/shaken bag fi lter in the container. Make
sure the fi lter support fi ts into the inner edge of the dust
container properly.
Check that the fi lter is fi tted the right way up - the cloth
handle on the fi lter should be visible, Fig. 21.
3. Replace the dust container on the vacuum unit. Close the
container on the vacuum unit by applying inward pressure
to the two handles to ensure the vacuum unit and dust
container are fi tted together properly.
Fig. 20
Fig. 21
Fig. 22
Fig. 24
Fig. 23
The Silver/Sopra 160, Gold/Sopra 260, Gold RRC/Sopra 260
RRC can be run with or without the installation of a dust
bag - the choice is yours. These products must though
always be operated with the bag fi lter fi tted in the cleaner.
To Next Page
Loading...
Need help?
General
