Nilfisk-Advance SW4000 Instructions For Use

ENGLISH INSTRUCTIONS FOR USE
2 SW4000, FLOORTEC R 870 - 1464815000
03/2013
INTRODUCTION
NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualied technicians must read this Manual carefully. Contact
Nilsk in case of doubts concerning the interpretation of the instructions and for any further information.
TARGET
This Manual is intended for operators and technicians qualied to perform the machine maintenance.
The operators must not perform procedures reserved for qualied technicians. Nilsk will not be responsible for damages coming
from failure to follow these instructions.
HOW TO KEEP THIS MANUAL
The Instructions for Use Manual must be kept near the machine, inside an adequate case, away from liquids and other substances
that can cause damage to it.
DECLARATION OF CONFORMITY
The Declaration of Conformity, supplied with the machine, certies the machine conformity with the law in force.
NOTE
Two copies of the original declaration of conformity are provided together with the machine documentation.
IDENTIFICATION DATA
The machine serial number and model name are marked on the plate (30).
Product code and year of production are marked on the same plate (Date code: A17, means January 2017).
The engine model and serial number are shown on the plate (59).
This information is useful when ordering machine and engine spare parts. Use the following table to write down the machine and
engine identication data for any further reference.
MACHINE model ...............................................................................
PRODUCT code ................................................................................
MACHINE serial number ...................................................................
ENGINE model ..................................................................................
ENGINE serial number ......................................................................
OTHER REFERENCE MANUALS
– Engine Manual, supplied with the machine (to be considered an integral part of this Manual).
Moreover, the following Manuals are available:
– Spare Parts List (supplied with the machine)
– Service Manual (that can be consulted at Nilsk Service Centers)
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair procedures must be performed by qualied personnel or by Nilsk Service
Centers. Only original spare parts and accessories must be used.
Contact Nilsk for service or to order spare parts and accessories, specifying the machine model, product code and serial number.
Revised 02/2017

Nilfisk-Advance SW4000 Specifications

General

Brand	Nilfisk-Advance
Model	SW4000
Category	Floor Machine
Language	English