Nilfisk-ALTO SCRUBTEC R 466 User Manual

USER MANUAL
ENGLISH
9098960000(1)2011-04 A SCRUBTEC R 466 - R 471 - R 471C - BOOST
®
R4 19
Squeegee adjustment
If necessary, stop the machine and turn the squeegee adjusting handwheel (35) so that the rear blade touches the fl oor along 1.
all its length.
Adjustment of the detergent concentration in the solution
(For machines with Chemical Mixing System)
The system used to mix the detergent with the washing water can be activated by pressing the detergent fl ow control switch (A, Fig.
5): when one of the LEDs is on, the detergent is added to the washing water.
The average detergent concentration varies according to the illuminated sector (B), as shown in fi gure 5.1.
Press the switch (A) to change the detergent concentration to reach the desired setting, or to reset (all LEDs off).2.
NOTE
Detergent percentage setting is stored into memory, even if the machine is turned off.
NOTE
The detergent concentration is kept constant even if the washing water fl ow is changed with the switches (C) or (D).
B
A
C
D
0,4%
0,5 Oz/Gal
0,75%
1 Oz/Gal
1,5%
2 Oz/Gal
2,5%
3 Oz/Gal
Figure 5
P100439
Working with brush/pad-holder extra pressure function turned on (only for SCRUBTEC R 466 / R 471 / BOOST
®
R4)
If the fl oor proves to be particularly diffi cult to clean, it is possible to turn on the brush/pad-holder extra pressure function by 1.
pressing the switch (67).
To return to normal pressure, press the switch (67) again.2.
The switch (67) is enabled only when the deck (5 and 10) is lowered and the LED (64) of the switch (63) is on.
CAUTION!
In case of brush/pad-holder motor overload, due to foreign bodies which prevent them from rotating, or to
excessively aggressive fl oors/brushes, the safety system stops the brushes/pad-holders after about one minute
of continuous overload.
The overload is shown by the three battery warning lights (62) fl ashing simultaneously.
If the overload takes place when the extra pressure function is on, the system automatically reduces the
pressure on the brushes/pad-holders, thus turning the extra pressure function off. If the overload persists, the
brushes/pad-holders stop.
To start scrubbing again after a brush/pad-holder stop due to overload, stop the machine by turning the ignition
key (58) to “0”. Turn on the machine by turning the ignition key (58) to “I”.
9098960000(1)2011-04 A.indb 199098960000(1)2011-04 A.indb 19 07/04/2011 15:59:2107/04/2011 15:59:21

Nilfisk-ALTO SCRUBTEC R 466 Specifications

General

Brand	Nilfisk-ALTO
Model	SCRUBTEC R 466
Category	Scrubber
Language	English