5-9
I4-1
OPERATOR’S MANUAL FOR INFANT INCUBATOR EDITION/REVISION B/0
Step 2: Rotate outer ring. If properly installed, the sleeve will open when reversing the rotation.
FIGURE 5.11
G. See figure 5.12, install the Access door gasket, and then isnatall the Access door cuff.
Inner wall of hood
Hood inner side
Access door gasket
Outside of hood
Installation groove of Access door cuff
FIGURE 5.12
H. Install the soft tubing in figure 5.13.
NOTE: The opening of soft tubing should face outward.
Opening
FIGURE 5.13
I. Install the Mattress cover with the mattress, and put the bassinet inside hood according to
the opposite order. (see Figure 5.2)
WARNING: Place the bassinet as the label indicates on the infant bed.
To Next Page
