© 2005-2016 Nira Control AB 113
6.9.4 Flatshift Recovery Time
Sets the time for the ramp up period, i.e. when the cut and ignition is phased
back to their normal state (0 % cut and the ignition angle calculated from in
Ign Main Table).
6.9.5 Flatshift Min Rpm
Sets the minimum rpm allowed for Flatshift activation.
6.9.6 Flatshift Min Tps
Sets the minimum throttle position allowed for Flatshift activation.
6.9.7 Flatshift Recovery Time
Sets the time delay after the ramp up is completed until a new Flatshift cycle
may commence.
6.9.8 Flatshift Cut
Sets how many percent of ignitions/injections should be blocked upon
Flatshift activation.
6.9.9 Flatshift Ign Ret
Sets how many degrees the ignition is retarded upon Flatshift activation.
NOTE! Negative values give retardation.
6.10 Traction Control
The traction control function allows the car to gain as much traction as
possible by lowering the torque output to the wheels. This is a highly
advanced function that can lead to driveline damages if the calibration and
installation aren’t performed in a correct way.
To Next Page
