© 2005-2016 Nira Control AB 98
Wrong MAP. Verify that the MAP sensor reading is around 100kPa
(ambient pressure) when the starter isn’t turning. The MAP parameter
is under “Mappings”-> Monitor Output -> 0.General -> Bv Manifold
Air Pressure. If you see a different pressure reading, the calibration is
wrong or the sensor is damaged.
5.4 Other Adjustments
Since you were able to start the engine you are now ready to begin adjusting
parameter values in order to improve engine performance. The next chapter
includes lots of advice on how to do this.
To Next Page
Loading...
