these heat shields are contaminated with fuel or oil, they must be cleaned before running the
diesel group.
To minimize the fire risk, below steps should be followed:
1. Make sure the engine is fully cooled before adding or discharging oil to drain the fuel
filter.
2. Please clean the exhaust pipe thoroughly.
3. Please replace all heat shields removed during maintenance.
1.4.13 Shutdown and Disassembly
At the end of the service life of a fire pump group, it must be shut down and disassembled
in accordance with local standards and regulations for the disposal/recovery of
components and contaminated liquids. This step must be performed only by properly
trained and experienced maintenance personnel.
2.0 TRANSPORTATION AND HANDLING
The transportation and handling of fire pump group must be performed only by properly
trained, experienced personnel who are familiar with the transportation of these products.
For enclosed fire pump group, the hatch door must be closed before changing position
and kept shutdown during transportation and placement.
1. Ensure the fire pump set is ready for transport. Drain the liquid if necessary and ensure
that no acid or aerosol leaks from the battery (if applicable).
2. Install the impact indicator on fire pump group if necessary. Upon acceptance, check
these impulse indicators and contact the shipping company immediately if any impulse is
detected. The impact can cause serious damage to the fire pump unit and its
components.
3. Do not overload of transport vehicle.
4. The fire pump shall not be started under any conditions during loading and
transportation.
2.1 Lifting
1. The action line of the sling is parallel to the outer surface of the corner joint, and the
distance shall not more than 38 mm (1.5 in.).
To Next Page
Loading...