5
Before installing the unit, check the container and the machine for damage. A dam-
aged container may be an indication there is possible damage to the machine. If there
is any type of damage to both the container and the unit, DO NOT THROW AWAY
THE CONTAINER. The dish-machine has been previously inspected at the factory
and is expected to arrive to you in new, undamaged condition. However, rough han-
dling by carriers or others may result in damage to the unit while it is in transit. If such
a situation occurs, DO NOT RETURN THE UNIT TO NOBLE. Instead, contact the
carrier and ask them to send a representative to the site to inspect the damage. You
should request that an inspection report be completed. You must contact the carrier
within 48 hours of receiving the machine in order to report possible freight damage.
You are also encouraged to contact the dealer through which you purchased the unit.
The machine should be unboxed and/or removed from the pallet prior to installing.
Open the front door and remove all of the materials from the inside. Once unpacked,
verify there are no missing parts to the best of your ability. If you discover a part is
missing, contact Noble immediately.
The dish-machine is designed to operate while level. This is important to prevent any
damage to the machine during operation and to ensure the best results possible. The
unit comes equipped with adjustable feet, which can be turned using a pair of channel
locks or by hand. Verify the unit is level from front to back and side to side prior to
making any electrical or plumbing connections.
All plumbing connections must be made to adhere to local, state, territorial and na-
tional codes. The installing plumber is responsible for ensuring the incoming water
lines are ushed of debris prior to connecting to the machine. Note that chips and
materials from cutting processes can become lodged in the solenoid valves and pre-
vent them from opening or closing. Any valves that are found to be fouled or defective
because of foreign matter left in the water line, and any subsequent water damage,
are not the responsibility of the manufacturer.
A water hardness test must be performed to determine if the HTS-11 (scale preven-
tion & corrosion control) need to be installed. A hardness test kit is attached to the
warning tag that is attached to the incoming plumbing connection on the back of the
machine. If the hardness is higher than 5 GPG the HTS-11 will need to be installed.
Please contact Noble immediately to have this shipped to you.
INSTRUCTIONS
INSTALLATION
VISUAL INSPECTION:
DO NOT THROW AWAY
CONTAINER IF DAMAGE
IS EVIDENT
LEVEL THE
DISHMACHINE:
UNPACKING THE
MACHINE:
PLUMBING THE
DISHMACHINE:
A water hardness test
must be performed.
To Next Page
Loading...
