Noble UL30 - DELIMING OPERATIONS; PARTS & COMPONENTS; CONTROL SYSTEMS

16
OPERATING INSTRUCTIONS
INSTALLATION
In order to maintain the dish machine at its optimum performance level, it will be
required to remove lime and corrosion deposits on a frequent basis. A deliming solu-
tion should be available from your detergent supplier. Read and follow all instruc-
tions on the label of the deliming solution.
NOTE: If this machine is equipped with a HTS-11, scale prevention and corrosion
control device, and lime is becoming a frequent problem, the cartridge needs to
be replaced. To order a replacement cartridge, call Noble immediately to have one
shipped to you.
To proceed with the deliming operation, ll the dish machine and add the correct
amount of deliming solution as recommended by the deliming solution manufacturer.
The water capacity of the tank can be veried on the specication sheet (s) of this
manual.
Perform the following operations to delime the dish machine:
1. Push Manual Switch on the front of the control panel.
2. Close the door (after adding the deliming solution).
3. Run the machine for the recommended period of time.
4. Press the Power Switch to turn the unit off and open the door.
5. Wait ve minutes, then inspect the inside of the machine. If the machine is not
delimed, run another time cycle as per the deliming solution’s instructions.
6. When clean, drain and re-ll the machine.
7. Run in MANUAL for 10 minutes to remove residual deliming solution.
8. Drain and re-ll the machine.
DELIMING
OPERATIONS