Nokia 6110 - Device Settings - Security and Enhancements; Security Code Management

Copyright © 2008 Nokia. All rights reserved. 77
Settings
Enhancement
To change settings of an enhancement, in the
Enhancement sett. view, scroll to an enhancement, such
as Headset, select Options > Open and from the following
options:
Default profile — to select the profile you want to activate
each time you connect the enhancement to your device
Automatic answer — to set the device to answer an
incoming call automatically after 5 seconds when this
enhancement is connected to your device. If the Ringing
type is set to Beep once or Silent, automatic answer
cannot be used, and you must answer the call manually.
Lights — to set the device lights continuously on while
using the enhancement, select On.
Security
Select Phone and SIM card, Certificate management, or
Security module.
Phone and SIM card
You can change the following codes: lock code, PIN or
UPIN code, and PIN2 code. These codes can only include
the numbers from 0 to 9.
Avoid using access codes similar to emergency numbers to
prevent accidental dialing of the emergency number.
Code in use — to select the active code, PIN or UPIN, for
the active USIM. This is shown only if the active USIM
supports UPIN, and the UPIN is not rejected.
PIN code request or UPIN code request — to set the
device to request the code each time the device is switched
on. Some SIM cards may not allow the PIN code request to
be turned Off. If you select Code in use > UPIN, UPIN code
request is shown instead.
PIN code or UPIN code, PIN2 code, and Lock code — to
change the codes
Keypad autolock period > User defined — to
automatically lock the keypad after a defined period of
inactivity
Phone autolock period — to set a time-out after which
the device is automatically locked. To use the device again,
you need to enter the correct lock code. To turn off the
autolock period, select None.
Lock if SIM card changed — to set the device to prompt
for the lock code when an unknown, new SIM card is
inserted into your device. The device keeps a list of SIM
cards that are recognized as the owner cards.
Closed user group (network service) — to specify a group
of people whom you can call and who can call you. For
more information, contact your service provider. To
activate the default group agreed on with the service