Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 571
The no form of this command disables the use of uniform FRR for LDP-over-RSVP LSPs.
Default no enable-ldporsvp-frr
qos
Syntax qos
Context config>system>glob-res-profile
Supported
Platforms
7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone
Description This command enables the context to configure the QoS resources.
port-scheduler-mode
Syntax no port-scheduler-mode
port-scheduler-mode
Context config>system>glob-res-profile
Supported
Platforms
7210 SAS-R6 and 7210 SAS-R12 (supported only on IMMv2 cards)
Description This command lets user select the queuing mode to be used for SAPs configured on all the
ports of the node.
When port-scheduler-mode is enabled, software allocates 8 egress queues per port and all
the SAPs configured on the access port or hybrid port will share the 8 egress queues for traffic
sent out of that port. In this mode, SAPs configured on hybrid port shares the egress queues
with network port traffic. Enabling port-scheduler-mode affects the behavior for all the SAPs
configured on all the access and hybrid port. In this mode, per SAP egress queues are not
available.
In this mode, resources allocated towards SAP egress queues in the ingress-internal-tcam
pool are not required by this feature and can be allocated towards other features. See the
qos-sap-egress-resource command for more information.
When port-scheduler-mode is disabled using the no form of this command, per SAP egress
queues are available for use. Refer to the 7210 SAS-M, T, Mxp, Sx, S Quality of Service
Guide for more information about the two modes.
Enabling or disabling port-scheduler-mode requires a reboot of the node.
Default no port-scheduler-mode

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English