System Management Guide Event and Accounting Logs
Edition: 01 3HE 11018 AAAC TQZZA 323
Default No destination is specified
Parameters size — defines the number of events stored in this memory log
Values 50 to 3000
Default 100
to syslog
Syntax to syslog syslog-id
Context config>log>log-id
Description This command instructs the alarms and traps to be directed to a specified syslog. To remain
consistent with the standards governing syslog, messages to syslog are truncated to
1 kbyte.
The command is one of the to commands used to specify the log ID destination. A to
command is mandatory when configuring a log destination.
The source of the data stream must be specified in the from command prior to configuring
the destination with the to command.
The to command can only be set once. It cannot be modified or re-entered. If the log
destination needs to be changed or if the maximum size of an SNMP log or memory log needs
to be modified, the log ID must be removed and then recreated.
Default No destination is specified
Parameters syslog-id — instructs the events selected for the log ID to be directed to the syslog-id.
The characteristics of the syslog-id referenced here must have been defined in the
config>log>syslog syslog-id context.
Values 1 to 10
time-format
Syntax time-format {local | utc}
Context config>log>log-id
Description This command specifies whether the time should be displayed in local or Coordinated
Universal Time (UTC) format.
Default utc
Parameters local — specifies that timestamps are written in the system’s local time
utc — specifies that timestamps are written using the UTC value. This was formerly
called Greenwich Mean Time (GMT) and Zulu time.
To Next Page
Loading...
