Event and Accounting Logs
324
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
5.12.2.1.8 SNMP Trap Groups Commands
snmp-trap-group
Syntax [no] snmp-trap-group log-id
Context config>log
Description This command enables the context to configure a group of SNMP trap receivers and their
operational parameters for a given log-id.
A trap group specifies the types of SNMP traps and specifies the log ID that will receive the
group of SNMP traps. A trap group must be configured in order for SNMP traps to be sent.
To suppress the generation of all alarms and traps, see the event-control command. To
suppress alarms and traps that are sent to this log-id, see the filter (log destination)
command. Once alarms and traps are generated, they can be directed to one or more SNMP
trap groups. Logger events that can be forwarded as SNMP traps are always defined on the
main event source.
The no form of the command deletes the SNMP trap group.
Default There are no default SNMP trap groups.
Parameters log-id — the log ID value of a log configured in the to snmp context. Alarms and traps
cannot be sent to the trap receivers until a valid log-id exists.
Values 1 to 99
trap-target
Syntax trap-target name address ip-address [port port] [snmpv1 | snmpv2c | snmpv3]
notify-community {communityName | snmpv3SecurityName} [security-level
{no-auth-no-privacy | auth-no-privacy | privacy}]
no trap-target name
Context config>log>snmp-trap-group
Description This command adds or modifies a trap receiver and configures the operational parameters
for the trap receiver. A trap reports significant events that occur on a 7705 SAR, such as
errors or failures.
Before an SNMP trap can be issued to a trap receiver, the to console, snmp-trap-group, and
at least one trap-target must be configured.
To Next Page
Loading...
