After Sales
Technical Documentation
RAE/RAK–1N
Service Software
Page 7– 11
Amendment 1 04/97
CMT Menu Structure –Testing and Adjustment
Testing and Adjustments
1 RF Controls
2 Adjustments
3 Call Simulation
4 Internal Audio Loop
5 External Audio Loop
6 Logic Controls
7 Run MCU Selftests
8 Set MCU Start–up Self–tests
RF Controls
1 Actie Unit (TX/RX)............................: RX
2 TX Power Level................................: 15
3 Operation Mode (Burst/Continuous).: Burst
4 TX Data Type (0/1/RND).............:..... 1
5 Continuous Mode Channel...............: 60
6 Channel............................................: 60
7 Monitoring Channel...........................: 1
8 AGC..................................................: 81
8 AFC..................................................: –54
Adjustments
1 Continuous Mode Channel...........: 60
2 TX Power Tuning
3 TX I/Q Tuning
4 RSSI Calibration
5 AFC Diagram
6 Noise Sensitivity
7 Charge Voltage Adjustment
8 Battery Voltage Adjustment
Call Simulation
1 TX Power Level........: 10
2 Channel....................: 60
3 Monitoring Channel 1: 1
4 Monitoring Channel 2: 1
5 Monitoring Channel 3: 1
6 Monitoring Channel 4: 1
7 Monitoring Channel 5: 1
8 Monitoring Channel 6: 1
Internal Audio Loop
1 Input (Int/Ext/Phf)......: Int
2 Output (Int/Ext/Phf)...: Int
3 Loop (On/Off).....: Off
External Audio Loop
1 Interface (HS/HF/PHF)....: HS
2 Make a Measurement
FREQUENCY /Hz 300 1000 3000
RECEIVED LEVEL
Logic Controls
1 Read A/D Converters
2 LCD test display (1/2)...............: 2
Set MCU Start–up Self–tests
1 ASIC BUS tests............... (On/Off).......Off
2 ASIC Timer & IRQX Test...(On/Off).....:Off
3 ASIC Timer & NMI Test......(On/Off):... Off
4 Audio Codec Test...............(On/Off)...: Off
To Next Page
Loading...