Setting up the FastMile 5G Gateway 2
20
User Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02464-AAAA-TCZZA-01
Connect the other end of the power adapter into an electrical outlet.
Starting the FastMile 5G Gateway 2
After the FastMile 5G Gateway 2 is connected to power, start the device by pressing
the power on/off button located on the back of the unit.
Figure 10 Location of the power on/off button
The LED on the front of the gateway will soon turn on and start blinking yellow to
indicate that the device is booting up. The LED is a multi-color LED that indicates
device status as well as signal strength.
When the booting-up phase is completed, the LED turns red to indicate the signal
search procedure. The FastMile 5G Gateway 2 starts searching for the best 5G
connectivity.
Note: Ensure that no cables are blocking the air flow on the underneath of the FastMile 5G
Gateway 2 to avoid overheating.
To Next Page
Loading...
