Nokia FastMile 2 - LAN Ipv6

WebUI screens
56
User Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02464-AAAA-TCZZA-01
You can configure the following LAN settings:
• IPv4 address
• subnet mask
• enable DHCP
• DHCP start IP address
• DHCP end IP address
• DHCP lease time
• static DHCP
Click Save Changes.
Configure a static route and bind a MAC address to a specific local LAN/IP address
by entering the MAC and IP address in the static DHCP text boxes.
Click Add.
Your values appear in the table below.
Repeat for all MAC addresses to be bound.
The configured MAC and IPv4 address appear in the table below. Click Delete to
remove any of the MAC address configurations.
LAN IPv6
Click LAN IPv6.
The Network/LAN settings/LAN IPv6 screen appears.
Figure 39 Network/LAN Settings/LAN IPv6 screen
Note: Check the DHCP range before you change the LAN IP. If you want to use the LAN
IP, which is included in the previous DHCP range, change the DHCP range first. Click Save.
Then, change the LAN IP.