64
Menu Description
Software Update By USB
The following steps will guide you through the update process.
1. Download the latest version from the NOMVDIC website and copy
the ๎le to a USB device.
2. Plug the USB device into the SERVICE port on the projector
connector panel, then go to: Home > Settings > Firmware Upgrade >
Software Update By USB.
3. Select Enter by pressing OK on the remote control.
4. The system will detect the Firmware version and display a dialog
message.
5. After selecting Yes, a progress bar will appear as the update process
begins.
6. After reaching 100% the projector will restart and the screen will
turn black for a few minutes. The whole process will take about 10
minutes.
7. After updating the Firmware, it will take a few minutes to restart the
projector.
NOTE: ๎ Use the USB device with FAT32 format.
OTA Reminder
Selecting Enable ensures the Internet-connected projector to display a
reminder when there is a newer software version available online.
Firmware Version Displays the software version.
To Next Page
Loading...
