63
Menu Description
Software Update Online
The following steps will guide you through the update process.
1. Go to: Home > Settings > Firmware Upgrade >
Software Update Online.
2. Select Enter by pressing OK on the remote control.
3. The system will check the NOMVDIC website (OTA) and display a
dialog message if there is new Firmware.
4. By selecting Yes, a progress bar will appear as the update process
begins.
5. Upon reaching 100%, the projector will restart. The whole process will
take about 10 minutes.
6. After updating the Firmware, it will take a few minutes to restart the
projector.
NOTE: The projector screen will be black for about 10 minutes during
the updating process.
To Next Page
Loading...
