Safety
1-7
E1999 Nordson Corporation
All rights reserved
104 330H
Issued 8/99
Manual 1-8
Table 1-1 contains the text of the safety label on this equipment. The
safety label is provided to help you operate and maintain your equipment
safely. See Figure 1-1 for the location of the safety label.
Table 1-1 Safety Labels
Item
Part Description
1 246 890
WARNING: Do not use halogenated hydrocarbon solvents in this system.
It contains aluminum parts and may explode. Cleaning agents, coatings,
paints or adhesives may contain halogenated hydrocarbon solvents. Don’t
take chances, consult your material supplier to be sure.
2 181 119
WARNING
SHIGH PRESSURE DEVICE
Read the instruction manual before operating and observe all
warnings.
SINJECTION HAZARD
Airless spray painting equipment can cause serious injury if the
spray penetrates the skin. Do not point the gun at anyone or any
part of the body. In case of penetration, adequate medical aid
must be immediately obtained.
SCOMPONENT RUPTURE
This system is capable of producing 172.4 bar (2500 psi)
pressure. To avoid rupture and injury, do not operate this pump
at a pressure higher than the rated maximum working pressure of
any component in the system (including but not limited to spray
guns, hoses, hose connections and heaters).
SFIRE
Static voltage is developed by airless spraying. The pump,
associated system, and object being sprayed must be grounded
to prevent static discharge sparks which could start a fire.
SSERVICING
Before servicing, cleaning, or removal of any part, set trigger lock
on gun, and always shut off power source; then carefully release
pressure in fluid portions of the system.
9. Safety Labels
To Next Page
Loading...
