Parts
8-1
E 1999 Nordson Corporation
All rights reserved
104 330H
Issued 8/99
Manual 1-8
Section 8
Parts
To order parts, call the Nordson Customer Service Center or your local
Nordson representative. Use this five-column parts list, and the
accompanying illustration, to describe and locate parts correctly.
Numbers in the Item column correspond to numbers that identify parts in
illustrations following each parts list. The code NS (not shown) indicates
that a listed part is not illustrated. A dash (—) is used when the part
number applies to all parts in the illustration.
The six-digit number in the Part column is the Nordson Corporation part
number. A series of dashes in this column (- - - - - -) means the part
cannot be ordered separately.
The Description column gives the part name, as well as its dimensions
and other characteristics when appropriate. Indentions show the
relationships between assemblies, subassemblies, and parts.
Item
Part Description Quantity Note
— 000 000 Assembly 1
1 000 000
S Subassembly
2 A
2 000 000
SS Part
1
S If you order the assembly, items 1 and 2 will be included.
S If you order item 1, item 2 will be included.
S If you order item 2, you will receive item 2 only.
The number in the Quantity column is the quantity required per unit,
assembly, or subassembly. The code AR (As Required) is used if the
part number is a bulk item ordered in quantities or if the quantity per
assembly depends on the product version or model.
Letters in the Note column refer to notes at the end of each parts list.
Notes contain important information about usage and ordering. Special
attention should be given to notes.
1. Introduction
Using the Illustrated Parts
List
To Next Page
Loading...
